Performance Increased With EDM Wire Cutting

1/05/2004

The FA-V Series from the POWER MASTER LINE of MITSUBISHI ELECTRIC

The highest possible productivity is achieved by dramatically increased cutting rates up to 500 mm²/min; this is achievable with the machine series from the POWER MASTER LINE. The machines are especially strong with very complex cutting conditions required in mould production, with the cutting of electrodes and complex form shapes. Normally, it is not possible to produce this type of workpieces, using the available conditions on a standard Wire Cut EDM Machine. In many cases, just to reach a compromise production method, it is necessary to use complex and expensive clamping methods to get the best cutting conditions. With complex workpieces, it is in most cases impossible to reach the optimum machine settings like nozzle clearance clamping conditions and machining parameters – in this case you will see the very special strength of the FA-V series. High workpieces, with changing cutting technologies caused by horizontal holes causing a non-ideal nozzle clearance – this is the actual challenge for a modern Wire Cut EDM. We are not talking about a machine, but about an intelligent conception.